Related Articles. Author Info Last Updated: January 4, Part 1. Inspect the scratches. Toothpaste works best for shallow scratches and scuffs on the reflective side. Scratches on the non-reflective label side should never be rubbed, and may have caused irreparable damage. If you have deep scratches, consider sending the disk to a disk repair service.
You could also try more abrasive treatments, such as a non-petroleum-based metal polish. Dampen a soft, lint-free cloth. Lightly dampen a cotton or microfiber cloth. You'll use this to clean grime off the disk. If you skip this section, the toothpaste could rub dirt particles into the CD, making the scratch worse. Avoid any rough or dusty materials. If the disk is visibly greasy or dirty, wipe it under running water.
Wipe the reflective side of the disk. Gently brush the wet cloth against the disk. Wipe each stroke outwards from the center, like a spoke on a bicycle wheel. Rubbing in circles increases the risk of damage. Dry the disk carefully. A dry cloth is more likely to damage the disk. One of these methods of drying are recommended instead: Place face down on a couple layers of paper towel and wait until dry.
Loosely wad a paper towel and brush from the center outward. Do not push onto the disk; the only pressure should come from the bending of the paper towel.
Part 2. Choose the toothpaste. You must use actual paste, not a gel toothpaste. The paste contains abrasive material that scrapes plaque off your teeth. This will sand down the scratched surface as well, hiding the scratch causing the laser to misread. If you're lucky, your toothpaste will list an abrasion rating, called RDA. Apply a small amount of toothpaste to the polishing cloth. A small dab should be enough. As before, use a clean, lint-free cloth such as cotton or microfiber. Gently rub the toothpaste over the disk.
Always move radially, from the center of the disk straight out to the rim. Do not rub in circular motions. Continue rubbing gently until the scratch is gone or nearly gone. This can take a few minutes. Next, wipe it down with the banana peel the inside. The wax from the peel will help polish and further clean the disk. To restore a damaged CD, apply a dot of non-gel formulat toothpaste to a cotton cloth and rub in a straight line from the center of the CD outward , covering any scratches.
Rinse off the toothpaste with water. As with the toothpaste fix, you can use shoe polish, lip balm, furniture wax, or even petroleum jelly. Again, rub it into the surface of the disc to fill the scratch. With a lint-free cloth, wipe of the excess wax, with a radial action. Isopropyl rubbing alcohol should be all you need for a clean CD.
Scratches on the label side of CDs can be a more serious problem. Because the reflective metal layer and data layer are so close to the surface of the label side of the disc, they can be damaged very easily. Clean Magic Eraser on walls, surfaces, bathrooms and kitchens, but its micro-scrubbing technology also works on cars. First, wash your car or at least the scratched area. Then, wet the Magic Eraser and gently rub the scratch. Magic erasers are usually used for cleaning up messes, but it turns out they also help to clean up scratches.
After thoroughly cleaning and drying the surface, apply a dot of white, non-gel toothpaste preferably containing baking soda to a damp, lint-free cloth. Using small, circular motions, rub the paste into the scratch for about 30 seconds. Dab a small amount of toothpaste onto the end of a cotton swab or clean, soft cloth.
Gently rub the cotton swab or cloth in circular motions on the screen until you see the scratch go away. After this, wipe your screen with a slightly dampened cloth to remove any excess toothpaste. Apply a small amount of toothpaste to a lightly damp rag and use small, circular motions with a bit of pressure over the scratch. Keep rubbing for about 30 seconds.
Before replacing the entire laser, just try cleaning it. Some cotton swab and some isopropyl alcohol goes a long way. Fortunately, laser replacements for many consoles are pretty cheap.
Alternatively, you could send your console over to eStarland for repairs because they offer the absolute lowest console repair prices out there. Hopefully, by this point, your scratched discs are working once again. On the other hand, toothpaste is great for buffing out scratches on your car— just not your games! Save my name, email, and website in this browser for the next time I comment.
This site uses Akismet to reduce spam. Learn how your comment data is processed. Share Tweet Pin It Share. Wackoid Got a tip or idea? Send us an email at wackoidmail gmail.
0コメント